How to Install cloaking Blocking Film

To Apply the adhesive-backed cloaking  Film to window, glass,  have the following items ready to use:

If you want to download this document,clicking it: how to install clocking film

Thoroughly clean the glass or plastic substrate of dirt,dust or oils using mild detergent if
necessary and squeegee the excess soap/water from the substrate

Use the tape to mark the area that the film will be applied (if the film is smaller than the
substrate.)

Peel the release film from the Nano Blocking Film half way back and spray the adhesive-side

of the film and the surface of the substrate with water.

Place the Nano Blocking Film carefully on the substrate while aligning the edges to the tape.

Remove the water and any air bubbles with the squeegee blade by gently squeezing the water from the center of the film toward the edges

NOTE: The squeegee may glide more smoothly over the top of the film if it is also sprayed with

water

Repeat Steps 3 to 5 for the other half of the film.

NOTE: Make sure to peel the release film evenly from both corners to prevent the film from creasing or folding over on itself

Remove the excess water with a dry,soft cloth

Remove the tape.

NOTE: Sometimes cut sheet to size is a bit hard, so it is easier to cut the film by balancing a ruler on  the window glass.

Remove protective cover after mounting job finished.